* Add fan speed percentage support to the API
* Add float fan speed percentage
* Add percentage support to automation and configuration
* Update Tuya fan
* Fix pylint warning
* Update API to use speed levels instead of percentage
* Use speed levels
* Fix type warnings
* MQTT component now converts between speed levels and enums
* Webserver now supports speed_level
* Update prometheus
* Remove low/medium/high settings from speed fan
* Remove unused enum
* Configurable speed levels for speed fan
* Remove unused import
* Rename speed_level->speed and speed_levels->speed_count
* Rename supported_speed_levels -> supported_speed_count in API and FanTraits
Field id stays the same in the protocol, so the change is not breaking for aioesphome.
* Fix some Tuya devices not handling commands sent without delay
* Also do not report WiFi status if MCU does not support it
* Support Tuya MCU 0x1c command (obtain local time)
* Use #ifdef USE_TIME to handle optional dependency on RTC
* Rename Tuya clock config variable to time to be consistent with the codebase
* Add tuya time configuration to test4
The Tuya MCU keeps its own internal minimum brightness setting. This value may
not match the minimum brightness setting for ESPHome, leading to some issues:
1. Dimming is limited--on some devices the default minimum is as high as 10%,
meaning the dimmest ESPHome will go is still quite bright.
2. HA will allow a user to set a value below the MCU minimum, but the MCU will
reject it and keep the previous setting, so the UI is confusing.
This PR adds a setting to configure the datapoint for setting the MCU minimum
brightness. If the setting is set, then ESPHome will synchronize the MCU's
minimum brightness with the one configured for ESPHome on startup.
* Start support for tuya climate devices
* Add tuya climate to test4
* Fix lint and cast
* Remove blank line
* Try to display accurate action based on observed behaviour.
* Fix action when in off mode
* Improve config dump
* merge use of CONF_SWITCH_DATAPOINT
Co-authored-by: Guillermo Ruffino <glm.net@gmail.com>
* Fix fan oscillation trait not being used
* Add fan direction support to SpeedFan
* Add fan direction to API
* Add fan direction support to BinaryFan
* Fix CI errors
* Fix python format
* Change some ordering to trigger CI
* Add test for the configuration
Trevor North